China 2901067000 Manufacturer, Supplier, Factory

Usage and Maintenance Notes Strictly match the model Different series of air compressors (such as GA, GHS, ZR, etc.) require the use of corresponding model-specific oils. Mixing or using the wrong type may cause equipment damage and affect warranty. Regular replacement and inspection Replace according to the specified cycle in the equipment manual (synthetic oil usually has a longer cycle than mineral oil), and replace oil filters, air filters, etc. at the same time. Regularly test the oil quality (such as viscosity, moisture content, impurity content) to avoid failures caused by deteriorated oil. Storage and refilling The oil needs to be stored in a sealed manner in a cool and dry place to avoid contamination; when refilling, ensure that the tools are clean to prevent impurities from entering the oil circuit system.

Atlas Copco Gear Trial Run and Inspection Preliminary Inspection Manually rotate the gear shaft to feel if the rotation is smooth, and check for any sticking, abnormal noise or eccentric vibration. Check if the lubrication path in the gearbox is unobstructed, and add gear oil to the standard level as per the regulations. No-load Trial Run Connect the power supply and conduct a short-term (5-10 minutes) no-load operation. Listen for any abnormal noises (such as metal friction sounds, high-frequency squeals) from the gearbox. After stopping the machine, check the temperatures of the bearings and gears (should not exceed the ambient temperature by 40°C), and observe for any oil leakage. Load Test Gradually load to the rated pressure and run for more than 30 minutes. Recheck the noise, temperature and sealing conditions, and confirm there are no abnormalities.

Maintenance and Replacement Precautions for the Bushings of Atlas Copco Air Compressors Original Factory Parts Preferred: It is recommended to use Atlas Copco's original bushings to ensure dimensional accuracy and material compatibility, avoiding secondary damage caused by sub-brand parts quality issues. Installation Precision: The replacement should be carried out by professional technicians. The interference fit between the bushing and the bearing housing, as well as the clearance between the bushing and the shaft neck, must be strictly controlled. Special tools may be used for press-fitting in necessary cases. Compliance Check: After installation, the rotor clearance should be detected using a feeler gauge or precise instruments to ensure it meets the technical standards. Lubrication Assurance: After replacement, the specific compressor oil should be added in accordance with the specifications. Before starting, ensure that the lubrication system is properly supplied with oil.

Gear transmission of the air compressor body: For Atlas Copco G/GA and other oil-injected screw compressors, "high-performance gear drive" is commonly used. The motor drives the main unit through a gearbox for speed increase, which is a transmission structure rather than a "gear motor".

Regularly replacing the Atlas Copco filter and separator kits is an important measure for maintaining the good performance of the air compressor, reducing energy consumption and lowering the risk of failures.

2901300009 The filter is used to separate oil from the compressed air, ensuring the purity of the output compressed air. Its filter material is usually made of ultra-fine glass fibers from companies such as HV in the US, Lydall, and Johns Manville. The filtration accuracy can reach 0.1μm, and the oil content in the compressed air can be below 3ppm, with a filtration efficiency of 99.99%.