China 2230000800 KIT Manufacturer, Supplier, Factory

1. loading solenoid valve ‌ : It adopts a two-position three-position normally closed structure and controls the on-off of the pipeline from the oil and gas tank to the intake valve through PLC instructions. When powered on, allow compressed air to enter the intake valve pipeline and open the intake port. When power is cut off, cut off the air passage and expel the residual air in the cylinder, then close the air inlet 2. Vent solenoid valve ‌ : Open the valve for two positions and two normal positions to ensure that the pressure in the oil and gas tank of the air compressor remains at around 0.2MPa when it is no-load. When the machine is shut down and unloaded, cut off the power and release the gas to the intake filter to prevent excessive pressure

Atlas Copco Common Problems and Risks Oil emulsification: This often occurs due to the failure to promptly drain condensate (such as when the drain valve of the oil separator is blocked). Regular drainage is necessary. After emulsification, the oil must be replaced immediately and the drainage system checked. Oil carbonization: Due to poor oxidation stability of the oil or excessive exhaust temperature (failure of the cooling system), carbon deposits will clog the core of the oil separator and the oil filter, resulting in increased pressure loss and increased energy consumption. In severe cases, it can cause the main unit to freeze. Abnormal oil level: Low oil level will lead to insufficient lubrication and cooling; high oil level will cause excessive oil content in the exhaust (the oil separator does not separate thoroughly), and oil needs to be added or drained according to the scale on the oil level gauge.

Atlas Copco 2901099800 is a 500-hour, 1000-hour, and annual maintenance kit, including air filters, oil filters, oil-gas separators filter elements, lubricating oil / coolant, O-rings, and gaskets.

The high-pressure rotor replacement kit of Atlas Copco is mainly applicable to equipment such as high-pressure compressors of the Atlas Copco brand. When the high-pressure rotor of the equipment is worn out, damaged or reaches a certain service life, which affects the normal operation and compression efficiency of the equipment, this kit can be replaced to restore the performance of the equipment.

Discharge piston: Performs reciprocating motion under the drive of air pressure or oil pressure, directly acting on the intake valve assembly to control the opening/closing state of the valve. Spring: Provides a restoring force. When the discharging signal disappears, it pushes the discharge piston back to its initial position, allowing the compressor to return to the loaded state. Sealing ring / guide ring: Ensures the sealing performance and motion stability of the piston within the cylinder, preventing medium leakage and reducing wear. Push rod or connecting rod: Connects the discharge piston with the intake valve, transmitting motion to achieve the linkage control of the valve.

As an original part, it has strict compatibility with specific series or models of air compressors from Atlas Copco (for detailed compatibility information, please refer to the equipment technical manual). It is an important component for ensuring the normal operation of the lubrication system and maintaining the stability of the equipment. When replacing the oil filter or performing related maintenance, it is necessary to ensure that the bracket is firmly installed and the seal is good to maintain the reliability of the entire lubrication system.