China 1621301400 SPRING Manufacturer, Supplier, Factory

Genuine Original Atlas Copco Parts by reliable China supplier: If you are still looking for a reliable supplier from China who can provide you worry-free Atlas Copco products with best prices, you are on the right page. Here lets present you with the 2906075200 Atlas Copco GA132-180W Oil Separator Kit.

Function: Filtering impurities: During the operation of the air compressor, the lubricating oil will generate metal debris due to friction with metal components, and the oil itself will also produce gums and other impurities due to heating and oxidation with air. The oil filter can effectively remove these impurities, such as metal particles and deteriorated oil substances. The filtration accuracy is usually between 5-15 μm, maintaining the cleanliness of the oil passage, preventing impurities from entering critical components such as bearings, gears, and main body cavities, reducing wear and extending the service life of the equipment. Ensuring lubrication effect: Ensure that the oil entering the main unit is pure, maintain good lubrication performance, allow the friction surfaces to be fully lubricated, reduce friction loss, and avoid faults caused by poor lubrication due to impurities, such as bearing damage, rotor seizing, etc. Preventing oil passage blockage: Prevent impurities from accumulating in the oil passage, ensure the smoothness of the oil passage, enable the lubricating oil to circulate normally, provide sufficient lubrication and cooling for each component, and prevent problems such as overheating shutdown caused by insufficient oil supply.

The air compressor sensor is the core of the "intelligent" operation of the equipment. By accurately sensing parameters such as pressure, temperature, and flow rate, it enables the transformation from "passive maintenance" to "active prevention". Choosing the appropriate sensor and performing proper maintenance not only extends the lifespan of the air compressor but also reduces energy consumption and shortens downtime due to failures, providing stable and reliable compressed air support for industrial production.

Atlas Copco 2906017500，The air intake valve of the air compressor is the core control component of the compressor. It is like the "breathing organ" of the entire system, precisely regulating the entry of air. Usually, the control system, based on the signal from the pressure sensor, drives the pneumatic piston or butterfly valve through an electromagnetic valve to change the opening degree. Inside the valve, there is a rotary check valve that quickly and tightly closes by relying on the counterweight and pressure difference. This protects the internal components of the main unit from wear and contamination.

Atlas Copco 0663211199,The O-ring is a seemingly insignificant yet crucial sealing component. It fills the gaps between components through elastic deformation and is responsible for ensuring the efficient sealing of liquid and gas media by the air compressor. They are suitable for secondary static and dynamic uses. The O-ring can be sealed radially or axially as a whole. The sealing is achieved during assembly through axial or radial movement within the air compressor. Although the O-ring is small, it is the key to ensuring the sealing performance, efficiency, and lifespan of the equipment. Correct selection, proper installation, and meticulous maintenance are crucial.

Atlas Copco 2901188900，,The principle of the air compressor maintenance kit: Replace worn parts, perform maintenance and troubleshooting, ensure safety,Air filter element Remove garbage from the bottom. The filter with grease needs to be soaked in foam-free detergent. Damaged filters need to be replaced. Oil separator To ensure high efficiency of oil-gas separation, it is necessary to pass the compressed gas from the collision and gravity separation compressor through the oil separation process. Safety valve It is necessary to ensure the quality and safety of pressure vessels. Professional adjustments are required. Lubrication system Test the oil quality with screw oil and maintain the lubrication of bearings and the lifespan of the compressor Maintenance process standardization 1. Shut down and power off: Turn off the power and hang warning signs 2. System depressurization: Close the water supply and gas supply valves 3. Disassembly and inspection: Use tools to disassemble the components. It is necessary to check the rotor alignment status and bearing damage 4. Component maintenance: Replace the filter and lubricate, etc