China Metal Maintenance Kit Pressure Sensor Manufacturer, Supplier, Factory

Atlas Copco Gear Trial Run and Inspection Preliminary Inspection Manually rotate the gear shaft to feel if the rotation is smooth, and check for any sticking, abnormal noise or eccentric vibration. Check if the lubrication path in the gearbox is unobstructed, and add gear oil to the standard level as per the regulations. No-load Trial Run Connect the power supply and conduct a short-term (5-10 minutes) no-load operation. Listen for any abnormal noises (such as metal friction sounds, high-frequency squeals) from the gearbox. After stopping the machine, check the temperatures of the bearings and gears (should not exceed the ambient temperature by 40°C), and observe for any oil leakage. Load Test Gradually load to the rated pressure and run for more than 30 minutes. Recheck the noise, temperature and sealing conditions, and confirm there are no abnormalities.

Suggestions for replacement or purchase of Atlas Copco air compressor pressure switch PS3-W6S: Due to the direct correlation between pressure switch and equipment pressure control accuracy and operational safety, it is recommended to use original accessories (serial number 1624962200) to ensure compatibility. During installation, it is necessary to set the correct upper and lower pressure limits according to the equipment manual to avoid equipment failure caused by parameter errors. If you need to confirm whether it is compatible with a specific model, please provide the complete model and serial number of the compressor and contact us.

Selection and Replacement Precautions Model Matching: The electromagnetic valves for different brands and models of oil injection screw compressors (including brands such as Atlas Copco) have different models. It is necessary to select the appropriate product based on the specific model of the compressor, working pressure, medium type (oil/gas), and other parameters. Quality Assurance: It is recommended to choose original factory or certified high-quality spare parts to ensure compatibility with the unit and long-term reliable operation. Installation and Maintenance: During replacement, power must be cut off and the machine must be shut down. Ensure the system is depressurized. After installation, check the sealing performance to avoid leakage; regularly clean impurities inside the valve to prevent jamming and functional impairment.

Atlas Copco Common Problems and Solutions Slip and Abnormal Noise: This is often caused by loose belts, oil contamination, or wear on the pulley grooves. Adjust the tension, clean, or replace the pulley. Excessive Breakage: This may be due to excessive tension, incorrect belt type, misaligned pulley grooves, or excessive load. Check and adjust as necessary. Severe Heating: This is usually caused by slipping or poor heat dissipation. Stop the machine immediately for inspection.

Maintenance and replacement instructions for the transmission shaft seal kit of Atlas Copco screw air compressors If oil stains or oil leakage are observed near the transmission shaft, or if the consumption of compressor lubricating oil increases abnormally, it may be due to the aging or damage of the seal kit. Therefore, it is necessary to check and replace it in time. When replacing, it is recommended to use the original kit and operate in accordance with the equipment manual to ensure that the seal is installed in the correct direction and tightly attached. In case of necessity, special tools can be used for installation to avoid deformation or damage to the seal.

Replacement Precautions Before installation, clean the oil stains and impurities on the interface surface to avoid scratching the sealing ring. Ensure a proper installation to avoid distortion or excessive stretching, which may affect the sealing effect. It is recommended to conduct regular checks and replace it in a timely manner according to the usage environment (such as humidity, temperature, and medium). Generally, it is advisable to replace it synchronously with the equipment maintenance cycle.