China atlas copco air compressor careers Manufacturer, Supplier, Factory

Maintenance suggestions: During installation, it is necessary to check whether the sealing surface of the flange is in good condition. Use the original factory sealant gasket and tighten the bolts according to the specified torque. This is to prevent air leakage or damage to the components due to improper installation.

1900520013 This controller is equipped with 3G connection functionality. It enables the machine to be connected to the cloud without any additional cost, facilitating users to conduct remote monitoring and management through Atlas Copco's Smartlink 2.0 monitoring system, thereby helping factories advance towards Industry 4.0.

Installation and Maintenance of Atlas Copco Screw Air Compressor Regulators During installation, ensure that the connection between the regulator, the air compressor, and the pipelines is sealed properly to prevent air leakage and affect accuracy. Regularly clean the sensing components of the regulator (such as diaphragms and sensors) to prevent impurities from blocking or wearing them out. For mechanical regulators, check the spring elasticity to ensure it is normal; for electronic ones, perform regular sensor calibration. If you encounter problems such as excessive pressure fluctuations or malfunctioning regulation, promptly repair or replace the regulator. When choosing an air compressor regulator, consider factors such as the power of the air compressor, the pressure requirements of the gas-using equipment, and the operating environment to ensure efficient and stable system operation.

Atlas Copco Maintenance and Replacement: Regularly inspect the wear, deformation or aging of the special-shaped rings . Replace them immediately if any abnormalities are found. When replacing, it is necessary to use the original or the same specification special-shaped rings. Standard rings cannot be used as substitutes . During the disassembly and installation process, avoid hitting the weak parts of the special-shaped rings, to prevent deformation and damage. Although the special-shaped rings of the air compressor are not universal, they play an irreplaceable role in special structural parts. Their design and manufacturing need to strictly match the specific requirements of the equipment, and special attention should be paid to precision and directionality during installation and maintenance to ensure the coordinated operation of all complex components of the air compressor.

Common Misconceptions and Risks Replacing only the oil but not the filter: Impurities accumulate, accelerating wear and clogging. Overdue use: Increased pressure difference leads to higher energy consumption and an increased risk of filter damage. Installation too tightly: May cause the base to deform or make future disassembly difficult.

ATLAS COPCO GA160 Operating Instructions Before operation, please read the equipment manual to avoid mistakenly modifying critical parameters (such as excessive pressure limit). When a red fault alarm occurs, stop the machine for inspection first, eliminate the fault, and then restart it. Regularly clean the control panel to prevent dust or oil stains from affecting the sensitivity of the buttons.