China Atlas Copco 2901056100 Manufacturer, Supplier, Factory

The air compressor oil filter is a key component of the lubrication system of an air compressor. It is mainly used to filter out impurities, particles and contaminants from the lubricating oil, ensuring that the oil entering the compressor meets the cleanliness standards, thereby protecting the internal components of the compressor (such as bearings, gears, rotors, etc.) from wear and damage, and extending the service life of the equipment. Working principle Physical interception: Through the microporous structure of the filter paper or filter element, particles larger than the pore diameter are mechanically filtered out. Adsorption effect: Some filter element materials can adsorb colloids and moisture, thereby enhancing the filtering effect.

GA22 VSD Application Scenarios Suitable for industrial scenarios with significant fluctuations in gas demand, such as mechanical processing, automotive manufacturing, electronics factories, food packaging, pharmaceuticals, etc. It can consistently provide high-quality compressed air for pneumatic tools, automated production lines, inspection equipment, etc. Maintenance and Advantages The maintenance period is long. Routine maintenance includes replacing the air filter, oil filter, oil-gas separator, and special compressor oil (such as original Atlas Copco lubricating oil). The VSD technology not only saves energy but also reduces the number of motor startups and stops, prolongs equipment lifespan, and lowers maintenance frequency.

The Atlas Copco UD + series of filters come in multiple specific models (such as UD9+, UD15+, etc.), each corresponding to different processing flow rates and applicable equipment. If you need to know the parameters, compatible models or purchasing information for a specific model, it is recommended to obtain detailed information through the official channels of Atlas Copco or authorized dealers.

Failure causes and maintenance suggestions for Atlas Copco Air compressor O-ring Common failure causes: Long-term high-temperature aging leads to reduced elasticity, wear or scratches (such as impurities entering the sealing surface), improper installation (such as twisting, being too tight), incorrect selection (material not suitable for the medium or temperature). Maintenance precautions: Regularly inspect the condition of the O-ring. Replace it promptly if it shows signs of hardening, cracking, deformation or leakage. When replacing, clean the sealing groove and mating surface, remove oil stains, burrs and impurities. Avoid using sharp tools to scratch the O-ring during installation. If necessary, apply special lubricating grease (compatible with the medium) to assist in installation. Select matching specifications and materials for the O-ring based on the air compressor model and location.It is recommended to use original factory parts to ensure the sealing effect.

High quality filtration The configuration and careful selection of the filter materials is key to all filters performance, ensuring maximum filter lifetime, minimal pressure drop and optimal quality of the outlet air.Prevent contamination All our filters are designed for your compressor and ensure a perfect fit preventing unfiltered air or oil from passing through.Reduce oil consumption Low oil carry over keeps your oil consumption to a minimum.

Fault and Replacement Suggestions: If the thermostat valve gets stuck (unable to open or close), it will cause: Low oil temperature (always bypassing the cooler): The high viscosity of the oil increases the load on the engine and energy consumption; High oil temperature (always on the cooling): Especially in low-temperature environments, the oil heats up slowly, and the lubrication effect declines. Suggestions: When you notice abnormal oil temperature (deviating from the normal range by more than ±10℃), check the status of the thermostat valve; When there is a fault, replace the original factory thermostat valve to avoid using an alternative part that leads to insufficient temperature control accuracy; When replacing, clean the pipe interface to ensure the correct installation direction of the valve (according to the arrow indication on the valve body), to prevent installation in the wrong position from affecting the function.