China 3001530300 Atlas Copco Manufacturer, Supplier, Factory

Discharge piston: Performs reciprocating motion under the drive of air pressure or oil pressure, directly acting on the intake valve assembly to control the opening/closing state of the valve. Spring: Provides a restoring force. When the discharging signal disappears, it pushes the discharge piston back to its initial position, allowing the compressor to return to the loaded state. Sealing ring / guide ring: Ensures the sealing performance and motion stability of the piston within the cylinder, preventing medium leakage and reducing wear. Push rod or connecting rod: Connects the discharge piston with the intake valve, transmitting motion to achieve the linkage control of the valve.

Atlas Copco 1631090801 Pipe G 1/4X245, G1/4 interface size, G represents imperial non-threaded sealed pipe thread, the thread size is 1/4 inch, 245 represents the pipe length.

Faults and Maintenance Suggestions Common Problems and Solutions: Poor or blocked drainage: This is often caused by accumulated impurities. You can disassemble the valve body to clean the filter screen. In severe cases, the original valve needs to be replaced. Valve always closed or always open: This may be due to a fault in the electromagnetic valve coil or damage to the controller. You need to check the circuit and replace the corresponding components. Leakage: Caused by aging seals. It is recommended to directly replace the entire drainage valve (the original kit includes all seals). During maintenance, it is necessary to regularly (every 3 months) check if the wiring is loose, clean the drainage outlet, ensure that the winter environmental temperature is not lower than 0℃, and prevent freezing and cracking.

ATLAS COPCO 1621049600 Maintenance and Replacement: During regular maintenance of the air compressor, it is necessary to check the condition of the gaskets. If any deformation, aging, or damage is found, they should be replaced immediately; After disassembly, if the gasket has undergone plastic deformation (such as a metal gasket), even if it is not damaged, it is recommended to replace it to avoid repeated use leading to sealing failure; When replacing, it is necessary to use gaskets of the same specification and material as the original ones. It is prohibited to substitute with different types of gaskets (such as using a rubber gasket instead of a metal gasket). Although the air compressor gaskets are small components, they are crucial for the sealing performance of the system. Choosing the appropriate gaskets and correctly installing and maintaining them can effectively reduce leakage faults, reduce energy consumption, and extend the service life of the air compressor.

The WSD250-750, as the original drainage component, has the best compatibility with Atlas Copco air compressors and post-treatment equipment. It can effectively prevent leakage or poor drainage problems caused by the mismatch of accessory part sizes.

The metal control panel instrument controller switch assembly of the Atlas Copco mobile air compressor, usage and maintenance precautions: Regularly clean the surface of the panel to prevent dust accumulation from affecting observation and operation; check the flexibility of the switch buttons to prevent sticking. Fasten the fixing screws of the panel to prevent components from loosening or poor contact due to equipment vibration. When replacing components, select original factory parts to ensure that they match the electrical parameters and installation dimensions of the model (such as XAS, XR series of mobile compressors). In humid environments, pay attention to protection to prevent moisture from seeping into the interior and causing circuit short circuits.