China 2906024100 Atlas Copco Manufacturer, Supplier, Factory

2205684100 Drain Valve: This automatic drainage valve provides a fully automatic drainage function for the water collected at the lower level of the compressed air system. Its maximum working pressure is 20 bar, and the drainage capacity is 0.88 US gallons per minute. The interface is G1/2.

The Atlas Copco air filter, with its multi-level filtration design and precise adaptability, provides reliable intake protection for the air compressor. It is a crucial maintenance component that ensures the long-term efficient operation of the unit and reduces the failure rate.

The rubber coupling used in Atlas Copco industrial compressors needs to be inspected regularly during maintenance for signs of aging, cracks, deformation or excessive wear. If any damage is found, it should be replaced immediately to prevent the failure of the coupling from causing transmission faults in the compressor and affecting the normal operation of the equipment. It is recommended to use Atlas Copco original factory parts for replacement to ensure compatibility with the equipment and performance.

Key points for replacement and maintenance: When replacing, the oil separator filter element should be replaced simultaneously. Also, check if the sealing gasket is aged. If necessary, replace it together to ensure a proper seal. Before installation, clean the oil stains and impurities on the interface surface. Tighten according to the specified torque to avoid over-tightening which may cause the shell to deform or under-tightening which may lead to leakage. Regularly (usually in accordance with the filter element replacement cycle, approximately 2000-4000 hours) check if there are any cracks, corrosion or deformation in the shell. Replace it promptly if any abnormalities are found.

Atlas Copco Gear Maintenance Tips Regular Inspection: Observe the condition of the gear tooth surface, measure the tooth clearance, and replace them immediately if any abnormalities are found. Lubrication Management: Use dedicated gear oil (or air compressor-specific oil), replace it regularly, and keep the oil level normal to avoid oil contamination. Installation Calibration: Ensure that the parallelism and perpendicularity of the gear shaft meet the requirements, and avoid uneven load operation. Load Control: Prevent the air compressor from operating under long-term overloading conditions, and reduce the fatigue damage to the gears. The design and maintenance of air compressor gears are crucial for the overall performance of the machine. High-precision gear combinations with a good lubrication system can significantly reduce operating noise, extend service life, and ensure the efficient and stable operation of the air compressor.

Atlas Copco Maintenance Tips: Regular Inspection: Remove the cylinder cover and clean the valve surface of oil stains and carbon deposits (especially for piston-type air compressors, as high-temperature lubricating oil can easily cause carbon deposits); Replace Wear Parts: Valve plates, springs, sealing gaskets, etc. are considered wear parts. When wear, deformation or aging is detected, they should be replaced in time; Keep Clean: Avoid introducing impurities during installation. The filter device of the intake system needs regular maintenance to reduce dust entering the cylinder. Although the cylinder cover valve is a small component, it directly affects the compression efficiency and operational stability of the entire machine. During daily maintenance, special attention should be paid to its sealing performance and operational flexibility. If any abnormalities occur, timely repairs should be carried out to extend the service life of the air compressor.