News

The control unit of the Atlas Copco injection-type screw compressor is designed with intelligence, which not only simplifies the operation and management but also significantly improves the operating efficiency and reliability of the equipment. It is the key guarantee for achieving the "efficient, energy-saving and safe" operation of the compressor. When choosing, it is necessary to match the corresponding specification of the control unit according to the compressor model and actual working conditions.

The control unit of Atlas Copco's injection-type screw compressors is designed with intelligence, which not only simplifies operation management but also significantly improves the operating efficiency and reliability of the equipment. It is a key guarantee for achieving the "efficient, energy-saving, and safe" operation of the compressors. When choosing, it is necessary to match the corresponding specification of the control unit according to the compressor model and actual working conditions.

Maintenance and precautions for the control unit of Atlas Copco air compressors Regularly check the display screen and buttons of the control unit to ensure they are functioning properly and that the heat dissipation and ventilation are adequate, to prevent the impact of high temperatures on performance. If a fault code appears, it is recommended to refer to the equipment manual for interpretation or contact the authorized service center of Atlas Copco for handling to avoid the expansion of problems due to self-operation. Some control units support firmware upgrades, and updates can be obtained through official channels to enhance functional stability.

When performing maintenance and replacement, it is recommended to refer to the official maintenance manual of the air compressor to confirm the specifications and parameters of the O-ring. Obtain the original accessories through our official channels to ensure the sealing effect and the operational reliability of the equipment, and avoid problems such as leakage and equipment failure caused by incompatible parts.

Maintenance and replacement suggestions for the air cooler kits of Atlas Copco industrial compressors: Regularly clean the dust, oil stains, and other debris on the surface of the cooler core (this can be done by blowing with compressed air or rinsing with a dedicated cleaning agent) to prevent blockages that may affect the heat dissipation effect. If there are abnormal increases in the cooling temperature after the process, leakage in the pipeline, or fan failures, it is necessary to check the condition of each component of the kit. If necessary, replace the original factory air cooler kit. During the replacement process, it must be operated by professional technicians to ensure a good installation seal, the correct fan rotation direction, and testing the cooling effect after the replacement to avoid failure in heat dissipation due to improper installation.

Atlas Copco air compressor sensor kit replacement and usage precautions: Sensor replacement should be carried out by professional technicians. Wiring and calibration must be done in accordance with the equipment manual specifications to ensure correct signal transmission. Before installation, the sensor installation position should be cleaned to avoid the influence of oil stains, dust, etc. on measurement accuracy. It is recommended to calibrate the sensors regularly (according to the equipment maintenance cycle) to ensure their measurement accuracy and extend their service life.