News

Maintenance precautions for the oil filter and air filter components of Atlas Copco air compressors: When replacing, clean the interior of the filter housing to avoid secondary contamination by residual impurities. When installing, ensure a proper seal to prevent air leakage (for the air filter) or oil leakage (for the oil filter). It is recommended to inspect both the air filter and the oil filter simultaneously. If one of them is severely clogged, it may indicate an abnormality in the environment or the system (for example, clogged air filter may lead to insufficient air intake, indirectly exacerbating oil contamination).

During use, it is necessary to follow Atlas Copco's recommendations to regularly inspect and replace the air filter components. Generally, when the operating environment of the equipment is relatively clean, the replacement cycle can be appropriately extended; if the environment is dusty, the replacement cycle should be shortened to ensure the normal operation of the air compressor and the quality of the compressed air. When replacing, it is necessary to select qualified accessories certified by us to ensure the filtering performance and equipment compatibility.

Common Problems and Maintenance Suggestions Oil deterioration: manifested as darker color (turning brown or black), the appearance of sludge, emulsification (becoming milky white). This is mostly caused by high-temperature oxidation, water contamination or pollution. It is necessary to replace the oil immediately and investigate the causes (such as cooling system failure, breathing device blockage). Abnormal increase in fuel consumption: may be due to the failure of the oil separator, clogging of the return oil pipe or damage to the sealing parts. It is necessary to check the relevant components and replace them. Selection Principles: Only Atlas Copco original oil or certified equivalent oil products must be used. Inferior oil will lead to severe carbon deposits, accelerated bearing wear, and even cause major failures such as engine stalling.

Selection and precautions for coupling accessories of Atlas Copco compressors Model matching: The original factory accessories should be selected based on the compressor model (such as GA, G series), power, speed, pipe diameter, and pressure level to ensure that the dimensions, strength, and compensation are compatible. Original factory advantages: The original factory couplings of Atlas Copco have been tested specifically and have a high matching degree with the equipment, which can avoid vibration, leakage or safety hazards caused by size mismatch. Installation guidance: When replacing, refer to the equipment manual. If necessary, operate by professional technicians. Pay special attention to the alignment calibration (for transmission couplings) and pre-tightening force control (for pipe couplings).

Maintenance Recommendations: Regular Inspection: Conduct an inspection every 3-6 months (or as per the equipment manual) to check if the muffler is damaged in appearance, or if the connection parts are loose or leaking air. Cleaning and Replacement: Shorten the maintenance cycle based on the operating environment (such as in areas with high dust or high humidity). In cases of severe blockage, disassembly for cleaning or direct replacement may be necessary. Compliance Replacement: Only use original or certified alternatives to ensure compatibility with the equipment's exhaust volume and pressure parameters, to avoid reduced equipment efficiency or safety hazards due to size mismatch.

Original factory parts and selection The model of Atlas Copco fan blades must be strictly matched with the air compressor model (such as GA series, GHS series, etc.). Different models have different dimensions, hole diameters, and blade quantities. Original factory parts can be purchased through our authorized channels to ensure compatibility with the equipment and avoid operational failures caused by size mismatches.