Industry News

Original Equipment Parts and Replacement Considerations The Atlas Copco gear set is a core component. It is recommended to preferentially use original equipment parts . The advantages of using original equipment parts are as follows: It perfectly matches the parameters of the main unit and the motor, ensuring transmission efficiency The material and processing accuracy meet strict standards, and the lifespan can reach 8-150,000 hours If alternative parts are chosen, the gear module, tooth count, tooth profile , center distance, etc. must be strictly verified to avoid operational failures due to size deviations. In summary, the Atlas Copco air compressor gear set, with its high-precision design and high-quality materials, ensures efficient transmission of the equipment. However, it is necessary to conduct regular maintenance to extend its service life and avoid the entire machine stopping due to gear failures.

Maintenance and Common Issues of 40°C Thermostat for Atlas Copco Air Compressors Regular Calibration: After long-term use, temperature drift may occur. It is recommended to calibrate with a thermometer annually to ensure accurate triggering at 40°C. Cleaning and Maintenance: If the sensing part is covered with oil or dust, it will affect the sensitivity of temperature measurement. It is necessary to wipe it regularly (operate in power-off state). Common Faults: Temperature Trigger Deviation: This may be due to the aging of the sensing element. Replacement of the same model thermostat is required. Contact Adhesion: Causes the cooling equipment to run continuously or fail to start. Check the contact condition and replace it if necessary.

Key Points for Bolt Installation and Maintenance of Atlas Copco Pre-tightening Torque: Appropriate torque should be applied according to the bolt's strength grade and connection requirements . Excessive torque can cause the bolt to break, while insufficient torque may result in poor sealing or loosening. Surface Treatment: The bolt surface is usually galvanized, phosphated , or oxidized . Before installation, check the surface for rust or damage. Cooperation Precision: The cooperation between the bolt and the nut or the bolt hole must comply with standards . Avoid overly loose or overly tight threads. Regular Inspection: After the air compressor has been running for a period of time, check if the bolts are loose. If rust, deformation, or fracture is found, replace the bolts of the same specification and strength in a timely manner.

Maintenance suggestions for the sliding sealing components of Atlas Copco air compressors: Regularly inspect the wear condition of the sealing parts (such as the opening gap of the piston ring, the leakage volume of the piston rod seal); Atlas Copco Ensure the normal operation of the lubrication system (oil mist lubrication or solid lubricant in no-oil conditions); Atlas Copco Filter the intake air (reduce dust and other impurities); When replacing the sealing parts, select the model and material that match the working conditions and ensure the installation accuracy.

Although the seals of Atlas Copco are considered wear-prone parts, they are crucial for the efficient and safe operation of the air compressor. Proper selection, regular replacement, and standardized installation can effectively reduce leakage faults, lower energy consumption and maintenance costs.

Atlas Copco Installation and Maintenance Guidelines During installation, it is necessary to clean the oil stains and impurities from the surface of the distance ring, ensuring a tight fit with the mating parts without any gaps or skew. Avoid striking the edge of the distance ring (especially thin-walled parts), as this may cause deformation and affect the dimensional accuracy. During maintenance and inspection, check if the distance ring is worn, deformed or cracked. If any abnormalities are found, it should be replaced promptly; otherwise, it may lead to a decrease in the assembly quality and operational stability of the air compressor, causing vibration, abnormal noise or leakage, etc. Although the distance ring is a small standard part, its accuracy directly affects the assembly quality and operational stability of the air compressor. When selecting and installing, it is necessary to strictly follow the requirements of the equipment manual.